LAB MANUALS

Aim: To implement diode clipper circuits and observe the output waveforms on the CRO.
 Requirements:
DC Power Supply (0-32V)                 1Function Generator                             1Resistor (10 K)                                    1Diode (IN4007)                                  1CRO                                                    1 Procedure:
1. Connect the circuit as shown in the fig.3.1
2. Give sinusoidal input of 16V(P-P), 1 KHz using signal generator
3. Observe the output wave form CRO in ac-mode
4. Sketch the observed waveform on a graph paper

                               

Circuit Diagram 2:

Circuit Diagram 3: